Methods to improve the performance of micro cultivator

The micro cultivator has a very high utilization rate in the agricultural industry and is an important force to ensure the spring planting and autumn sowing of farmers. It is very important to improve the performance of the micro cultivator. The improved performance of the micro cultivator can not only improve the farming efficiency, but also reduce the labor intensity of farmers. The methods to improve the performance of the micro cultivator are as follows:

1. The maintenance shall be in place

During work, due to the friction and vibration of parts and components, and the invasion of mud, oil and water, it is inevitable that the connection will be loose, the parts and components will be worn, corroded and aged, which will deteriorate the state of the micro cultivator, increase the oil consumption, accelerate the wear, reduce the power, and constantly appear faults. Poor cooling effect, weak machine, difficult startup, insufficient power, etc. are typical faults caused by insufficient maintenance. To sum up, we found that it is very important to improve the performance of the micro cultivator from the running in of the new cultivator, correct operation methods, avoid long-term overload work, and do well in daily maintenance. Therefore, farmers need to operate the micro tiller in strict accordance with the requirements of the manual.  

2. The operation method shall be in place

During operation, first of all, avoid long-term overload operation. Do not tilt your head for a long time, otherwise it is easy to cause poor engine lubrication. When working in paddy fields and hard fields, if the machine is found to emit black smoke, it is necessary to downshift in time.

Secondly, in case of abnormal noise, the machine shall be shut down for maintenance, and can be restarted only after troubleshooting; Various clearances shall be adjusted frequently; When turning, lift the armrest. Do not turn with the power-assisted tiller knife. It is easy to break the power-assisted tiller knife.  

3. The running in of the new machine should be in place

Many people think that running in is not only a waste of time and fuel, but also uneconomical; Some people use the accelerator at high speed without running in. Others don't know how to run in and think it's OK to idle for 2~3 hours. According to experts, running in is a step-by-step process. It needs to start from the low gear, low speed and low load of the accelerator, and gradually increase to the high gear, high speed and large load. It is not urgent to achieve.